![]() ![]() ![]() Once boat-side and in range reach over the fish and pull the gaff head towards you. Slowly pump in and out of gear and keep pace as the angler draws the fish closer. Control the fish with a tail rope or other strategically-placed straight gaffs.įor a pelagic that does not circle, run the boat parallel to the fish. #Flying harpoon free#Keep in mind any extra pressure applied should free the head. If it doesn’t separate use it as a straight gaff for the time being. The fish should react by pulling the gaff head free. When the fish comes out from under the boat reach in front of it and over its back, pull the hook into the tuna and towards the boat. The circles will decrease in size as the fish gets closer to the boat. If fighting a tuna, it should set into a pin wheel or circular pattern as it approaches the boat. Again, watch and get in sync with the fish before you attempt to gaff it. This will prevent accidents and keeping the slack on deck will prevent fouling it in the props. Bring the rope back in hand over hand and coil it neatly as it comes back. Be sure to be mindful of the rope and any slack. Having the main line connected to a basket of thin rope will allow you to let the fish run. If the shaft is connected to the rope, make sure to undo it in case the fish runs. Most of the time there is no need to throw or let go of the handle, you simply need to poke it hard and pull the handle back. The process involves sticking a fish with a removable dart. Stop and think about this: we are not talking about throwing a harpoon at Moby Dick. The use of a harpoon is so simple and effective that the IGFA disallows it from their rules. The best options are the harpoon and fly gaff, but knowing how and when to use them is very important in the inevitable success. If the fish is larger but subdued, a straight gaff accompanied by a tail rope will do the trick. If it’s small enough and you can control the fish, a straight gaff is fine. There are three main ways to harvest a large fish a straight gaff, harpoon and fly gaff. Now that you understand how it’s done, it’s time to explore what tools are best suited for the task at hand. The gaff man then steps in and takes his shot. The angler is responsible for ensuring the line doesn’t tangle on the mate or rod as the fish is wired. The wireman takes over as the angler eases the drag back and backs up away from the gunnel. Walk the fish to whichever side is easiest to manage.Īs the fish gets close bring it within range and get ready to strike or release it. If fighting a marlin or shark, run with the fish and try to stay parallel to it. If fighting a tuna, keep the boat ahead of it running forward in the same direction, but in slightly larger circles. Find a rhythm and move the boat in a way to ensure there is no contact. If the line contacts the running gear or hull you may very likely lose the fish. To simplify the process the captain’s main objective is to keep the fish clear of the boat. #Flying harpoon how to#The first consideration is how to run the boat. This will not only increase your odds of landing a trophy, but it will enable you to safely release fish too. There are two parts that must be mastered in order to be successful: running the boat and taking the fish. Yet very few recreational captains have a game plan or practice how to be successful in landing large fish. I’d be willing to guess that when a trophy fish is lost, 95 percent of the time it happens boatside. When that next tournament-winning fish comes boatside, it will pay off bigtime to have the right tool for the job and know how to properly use it.Īs offshore fishing grounds have become more accessible to smaller boats, many new techniques must be learned. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |